you probably could get the 3" hellbent steel leveling kit assuming you have the 2" and then get some aftermarket UCA's that allow less stress on the balljoints
Better be one hell of a weld.And you better be one hell of a welder.Especially if you plan on off roding.I mean to the point you better double weld that biatch N yes it can be done.But i wouldnt recomend it.
I agree.I know ppl that have done that.Yet they seem to be 3 chevy guys that work at Trucks&Cars unlimited.Thats bad enough.
If I do end up addin to the strut it'd be welded good and look factory when I got done. I would put a piece in the void spot and weld/grind flush and put the next size pipe over it and weld at each ends. Not sure what I'll do just lookin for options
I guess I could always take a cutoff wheel to the plastic inner fender thats in the way. I'll have to do some trick cuttin on the fender trim though